Selector Unit Removal - Gilera SMT RCR 633793 Service Station Manual

Engine
- Use a dial gauge to check the clearance between
the connecting rod and the crankpin on the X and
Y axes as indicated in the photograph
Characteristic
Serviceability limit:
0.35 mm
- Make sure that both half shafts are not scratched
or abnormally worn
- Use two dial gauges and a support as indicated
in the photograph to check the deviation of both
half shafts
Characteristic
Serviceability limit:
0.05 mm

Selector unit removal

- Remove the clutch unit
- Remove the gear pedal (1)
- Remove the shaft/selector unit (2) by pulling it
outwards
ENG - 64
SMT RCR