Thermostat Removal; Thermostat Check - Gilera SMT RCR 633793 Service Station Manual

Cooling system
- Fit the hydraulic pump shaft and the transmission
pinion
- Insert the washer (3)
- Fit the crankcase cover
- Fit the pump rotor (1) and its screw
Locking torques (N*m)
Pump rotor:
2 Nm
- Insert the gasket on the pump cover, the cover and the two sleeves
- Pour recommended oil in the transmission
- Fill up the cooling system
- Fit the other parts following the removal procedures but in reverse order
Thermostat
Removal
- Drain out the cooling system
- Detach the sleeve from the cylinder head
- Undo the thermostat screw (1) and the thermo-
stat itself
- Take out the thermoswitch fitting (2)
- Detach the thermoswitch (3)
Check
Thermoswitch check
- Immerse the thermoswitch in hot water to check
its resistance
- The thermoswitch should not get into contact with
the container walls or bottom; otherwise, the read-
ing will not be accurate.
1 - Thermometer
2 - Thermoswitch
- Replace the thermoswitch if the results do not fall
within the specification values
COOL SYS - 104
SMT RCR