Chassis
Radiator fitting
- Fit the radiator following the removal procedures but in reverse order
- Fill the reservoir with the recommended coolant and make sure there are no leaks in the system
Locking torques (N*m)
Radiator clamps: 8 ÷ 10 Nm
Expansion tank
- Remove the side Fairings
- Drain out the expansion tank
- Remove the two screws shown in the figure and
the pipes connected to the reservoir
- Remove the reservoir
Mixture oil tank
- Remove the saddle
- Remove the rear fairings
- Remove the oil intake pipes and drain out the
mixer oil reservoir
- Remove the electric connections from the oil level
indicator
- Slide off the reservoir from its seat
Battery
Battery compartment
- Remove the rear mudguard
- Remove the side fairings
- Remove the two screws indicted in the photo-
graph and then remove the battery compartment
CHAS - 112
SMT RCR