Gilera SMT RCR 633793 Service Station Manual page 85

SMT RCR
- If the throttle valve is replaced, fit another one
with the standard settings indicated on the upper
part as shown in the photograph
- Refit the complete the carburettor
- Refit the carburettor to the engine, connect the
fuel pipes again, the mixer oil intake pipes and the
low-pressure pipe for the fuel cock control
Adjusting the idle
- Tighten the flow set screw slowly until it stops and
then unscrew it as many turns as specified for this
type of engine (1+1/4)
- Remember this is the first adjustment
- Warm the engine up to the regular operating tem-
perature
- Adjust the idle speed at 1600 ± 200 rpm by op-
erating on the idle speed set screw (2)
- Turn the flow set screw (1) to both directions until
the maximum rpm possible is obtained
Engine
ENG - 85