Gilera SMT RCR 633793 Service Station Manual page 90

Suspensions
- Prepare a support with two gauging blocks in X.
- Position the stem as shown in the photograph
and use a dial gauge check alignment.
Serviceability limit: 0.2 mm
- Check the fork spring length.
- Make sure the spring does not show any signs of
abnormal wear or distortions. Replace it if it does.
- Check if the return spring and the guide nylon ring
are in good conditions. Replace them if damaged
or distorted.
- Thoroughly clean all the components.
Refitting
Carry out removal operations in reverse order being careful to observe the following tightening torques:
Fork stem cap
Fork plate upper clamp
SUSP - 90
REFITTING
Name
SMT RCR
Torque in Nm
17 ÷ 19 Nm
8 ÷ 10 Nm