Refitting The Flywheel Magneto - Gilera SMT RCR 633793 Service Station Manual

SMT RCR
- Undo the three fixing screws and remove the sta-
tor from the crankcase

Refitting the flywheel magneto

- Align the symbol (1) on the stator with the centre
of the arrow (2) on the crankcase and fix it with 3
screws
- Connect the stator cables with the high voltage
coil and fix them to the chassis with the brackets
- Make sure the cable support inside the crankcase
is correctly positioned so that the cables do not get
into contact with the flywheel rotor
- Fit the flywheel rotor making sure that the wrench
is aligned with its guide
- Lock the flywheel using the specific calliper span-
ner and tighten the flywheel fixing nut
- Fit the other parts following the removal steps but
in reverse order
Specific tooling
020565Y Flywheel lock calliper spanner
Locking torques (N*m)
Flywheel
35 ÷ 45 Nm
Engine
ENG - 57