Gilera SMT RCR 633793 Service Station Manual page 83

SMT RCR
Engine
- Use scales to check the float weight. Weight: 3.5
g
- Replace the float if higher weight values are
found
- Make sure the tapered pin is in good conditions.
Replace it if damaged or distorted
- Make sure the starter control piston is in good
conditions
- Replace it if it shows signs of abnormal wear
- Check that the calibration of the nozzles is ade-
quate (refer to the carburettor calibration table)
- Failure to observe these values compromises
engine performance
ENG - 83