Gilera SMT RCR 633793 Service Station Manual page 70

Engine
- Thoroughly clean and degrease all the gearbox
components, the selector and the shaft with a de-
greasing agent
- Refit the secondary shaft making sure all com-
ponents are fitted correctly
- Refit the gearbox unit in the crankcase (the main
and the secondary shafts must be fitted at the
same time)
- First check the overall size of the secondary shaft
including shim washers. Overall size of the sec-
ondary shaft: Max. 87,700 mm. MIN. 87.350 mm
- Fit the selector. Lubricate the surfaces with spe-
cific oil
- Make sure that the gearbox works properly by
selecting different speed ratios and turning the
gear selector drum to both sides
- Select neutral gear and check that the system
rotates freely
- Refit the crankcase by warming up the shaft
seats at about 60°
- Tighten the screws to the prescribed torque
- Make sure the crankshaft and the gear rotate
freely after refitting the crankcase
Recommended products
AGIP CITY HI TEC 4T oil to lubricate flexible
transmissions (throttle control)
Oil for 4-stroke engines
Locking torques (N*m)
Tightening torque:
6 Nm
Removing the clutch
ENG - 70
SMT RCR