Right Cover - Gilera SMT RCR 633793 Service Station Manual

Engine
020565Y Flywheel lock calliper spanner
Locking torques (N*m)
Flywheel
35 ÷ 45 Nm

Right cover

- Remove the engine protective cover
- Remove the rear brake pump
- Detach the coupling connecting the radiator to
the hydraulic pump and drain the coolant out of the
cooling system
- Detach the coupling connecting the hydraulic
pump to the cylinder
- Remove the clutch lever and detach the cable
clamps from the clutch
- Drain the oil out of the gearbox and the clutch
- Remove the oil pump cap
- Partially lift the lockscrew fixing the oil cable with
the aid of a small screwdriver
- Rotate the pump valve control anticlockwise and
detach the oil pump cable
- Remove the hose support
- Undo the two screws fixing the oil pump
- Move the whole oil pump unit and its hoses to-
wards one side of the carburettor but do not detach
them
- Remove the clutch cover
- Remove the clutch cover bolts
- Remove the crankcase cover gasket and clean
off any rest of old gaskets that may remain on the
crankcase or the cover
ENG - 74
SMT RCR