Braking system
Specific tooling
020329Y MityVac vacuum-operated pump
Front brake pump
- Operate on the two U bolt clamps (see figure).
- Disconnect the pipe and collect the brake oil in a
container.
- Upon refitting, perform the operation but in re-
verse order.
- Tighten the hydraulic line to the prescribed torque
and purge the system.
Rear brake pump - combined
Rear pump replacement
- Disconnect the pipe and collect the brake fluid in
a container.
- Remove the pump by undoing the two clamps
shown in the figure.
- Upon refitting, carry out the removal operations
but in reverse order observing the tightening tor-
ques.
CAUTION
AVOID CONTACT OF THE BRAKE FLUID WITH YOUR
EYES, SKIN, AND CLOTHING. IN CASE OF ACCIDENTAL
CONTACT, WASH WITH WATER.
WARNING
BRAKE CIRCUIT FLUID IS VERY CORROSIVE; DO NOT
LET IT COME INTO CONTACT WITH PAINTED PARTS.
CAUTION
THE BRAKE FLUID IS HYGROSCOPIC, THAT IS, IT AB-
SORBS MOISTURE FROM THE SURROUNDING AIR. IF
THE LEVEL OF HUMIDITY IN THE BRAKE FLUID EXCEEDS
A GIVEN VALUE, BRAKING EFFICIENCY WILL BE RE-
DUCED.
Locking torques (N*m)
Brake pump clamps
17 ÷ 19 Nm *
BRAK SYS - 100
SMT RCR