Gilera SMT RCR 633793 Service Station Manual page 62

Engine
- Remove the engine from the chassis and rest it
on the engine support
- Remove the thermodynamic unit (cylinder head
and piston)
- Remove the magneto flywheel
- Remove the main gear, the kick start and the gear
selector lever
- Remove the fixings screws of both crankcase
halves located to the left of the engine
- Remove the intermediate gear located at the end
of the gearbox
- Remove the gearbox star
- Warm up the seats of the crankshaft, the main
shaft, and the secondary shaft on both sides at
about 60°
- Place the crankcase on a wooden support as
shown in the photograph
- Separate the two crankcase halves with the spe-
cific tool
Never use a lever or a screwdriver to separate the
crankcase halves. Replace the crankcase halves
if the coupling surfaces get damaged.
Specific tooling
00H0530015.1 Engine opening tool
ENG - 62
SMT RCR