Removing The Carburettor; Reed Valve - Gilera SMT RCR 633793 Service Station Manual

Engine

Removing the carburettor

Reed valve

- Remove the carburettor from the engine
- Remove the reed valve and its gasket from the
crankcase
- Check that the valve petals are not damaged or
distorted. Replace them if they are.
- Remove the plate limiting reed opening by undo-
ing the three screws fixing the reed support
- Fit the valve following the removal procedure but
in reverse order; make sure the plate limiting reed
opening has been correctly positioned
- Absence of the plate limiting reed opening com-
promises the engine performance and reliability
- Check the O-ring of the reed support. Replace it
if damaged or distorted
(TYPE: PHVA 14)
ENG - 80
SMT RCR