Crankcase Fitting - Gilera SMT RCR 633793 Service Station Manual

SMT RCR
Engine
- Undo the screw of the gear selector lever (1)
- Undo the screw of the drum control head (2)
- Unscrew the drum control pin
- Make sure that the selector shaft springs and the
gear selector lever spring have been correctly fit-
ted
- Check that the selector shaft is not worn or dam-
aged
- Fit the parts following the removal procedures but
in reverse order
- Apply one drop of Loctite 270 on the thread of the
screw of the drum control head

Crankcase fitting

- Fit the new gaskets on the hydraulic pump shaft
with the aid of the specific tools
- Fit the first gasket with its rim facing inside and
the second gasket with the rim facing outside
Specific tooling
020376Y Adaptor handle
020441Y 26 x 28 mm adaptor
020455Y 10-mm guide
- Fit the hydraulic pump shaft
- It is crucial to make sure that the washer is cor-
rectly fitted
- Fit the pump rotor and fix it with its nut
- Fit a new gasket on the pump cover and then fit
the pump cover
ENG - 65