Gilera SMT RCR 633793 Service Station Manual page 63

SMT RCR
Engine
- Fit the specific tool from the flywheel side wall
- Remove the crankshaft after warming up the
shaft seat at about 60°
Specific tooling
00H0530015.1 Engine opening tool
- Take out the selector guiding fork and the selec-
tor
- Take out the two gear shafts at the same time
- Thoroughly clean and degrease the crankshaft
and then inspect it
- Use a thickness gauge to check the clearance
between the connecting rod head and the half
shaft
Characteristic
Serviceability limit:
0.8 mm
ENG - 63