Electrical system
- Check that the resistance between the terminals and the earth complies with the values indicated in
the table.
Lights list
1
2
3
Fuses
The electrical system is protected by a 4 ampere
fuse «B» located on the fuse box «A» on the bat-
tery positive cable. Before replacing a blown fuse,
find and solve the problem that caused it to blow.
Do not substitute the fuse with any alternative form
of conductor
Sealed battery
Sealed battery start-up operations
INSTRUCTIONS FOR REFRESHING THE STOCK CHARGE OF AN OPEN CIRCUIT
1) Voltage check
Before installing the battery on the vehicle, check the open circuit voltage with a normal tester.
- If the voltage exceeds 12.60 V, the battery may be installed without any renewal recharge.
- If voltage is below 12.60 V, a renewal recharge is required as explained in 2).
2) Constant voltage battery charge mode
-Constant voltage equal to 14.40÷14.70V
-Initial charge voltage equal to 0.3÷0.5 for nominal capacity
-Duration of the charge: 10 to 12 h recommended
Minimum 6 h
Maximum 24 h
ELE SYS - 44
BULBS
Specification
Front headlamp bulbs
light/stop bulb:
Turn indicators bulb:
SMT RCR
Desc./Quantity
12V. 35/35 W.
Type: Twin filament
12 V, 21/5 W
Type: Twin filament
12 V, 10 W