SMT RCR
Engine
- Loosen the screws fixing the clutch shaft and re-
move it
- Undo the three screws fixing the hydraulic pump
and remove it
- Detach the gasket and clean off any rests of old
gaskets that may be left on the coupling surfaces
of the hydraulic pump
- Lock the driving gear (1)
- Unscrew the fixing nut (2) first and then the rotor
(3). Push the driving gear, remove the hydraulic
pump and the gaskets
- Remove the seeger ring (4)
- Remove the oil pump (5)
Main transmission pinion
- Remove the crankcase right cover and the clutch
hub
ENG - 75