IMO Jaguar CUB Instruction Manual page 51

If you press the or key in any conditions other than those described above, the following will
appear:
Frequency
Frequency
setting from Multistep fre-
command 1
communica- quency setting
(F01)
tions link
0 Disabled
Other than the above
(3) Monitor the Running Status
In Running mode, the seven items listed below can be monitored. Immediately after the inverter is
turned on, the monitor item specified by function code E43 is displayed. Press the
between monitor items.
Display Sample on
Monitor Items
Speed monitor
(Hz, rpm, m/min, min)
Output current (A)
Input power (kW)
Output voltage (V)
PID process command (Note 1)
PID feedback amount (Note 1)
Timer (sec) (Note 1)
(Note 1) The PID process command and PID feedback amount are displayed only under the PID
control using a process command (J01 = 1 or 2). Further, the timer (for timer operation) is
only displayed when timer is enabled (C21 = 1).
(Note 2) The dot in the lowest digit will blink.
(Note 3) The dot in the lowest digit will light.
(Note 4) A positive integer is displayed.
PID control can-
Displayed using
celled
PID enabled
Disabled Frequency setting by keypad
Cancelled
PID output (as final frequency set-
PID enabled
ting)
Manual speed command currently
Cancelled
selected (frequency setting)
Table 3.3 Monitor Items
Meaning of Displayed Value
the LED monitor
50.00
Refer to Table 3.4.
Detected output current.
1.90A
A
: An alternative expression for A (ampere)
Detected input current to the inverter in Amp.
0.40P
P : An alternative expression for kW (kilo watt)
Commanded output voltage.
200U
U
: An alternative expression for V (voltage)
(PID process command or PID feedback
10.00.
(Note 2)
amount) (PID display coefficient A – B) + B
PID display coefficients A and B: Refer to
9.00.
(Note 3)
function codes E40 and E41
6
(Note 4) Remaining effective timer count
3-9
or key
key to switch