Problems With Inverter Settings - IMO Jaguar CUB Instruction Manual

Possible Causes
(3) The automatic
deceleration was active.
(4) Overload
(5) Torque generated by the
motor was insufficient.
(6) An external frequency
command device is being
used.
[ 7 ] Even if the power recovers after an instantaneous power failure, the motor does not
restart.
Possible Causes
(1) The setting of function
code F14 did not make the
motor restart even if the
power recovered after an
instantaneous power
failure.
(2) The run command stayed
off even after the power
recovered.

6.2.2 Problems with inverter settings

[ 1 ] If the data of function codes cannot be changed
Possible Causes
(1) An attempt was made to
change function code data
that cannot be changed
when the inverter is
running.
(2) The data of the function
codes is protected.
What to Check and Suggested Measures
Check the data of function code H69.
Consider the use of a braking resistor.
Increase the deceleration time (F08 and E11).
Measure the output current.
Reduce the load.
Check that the motor starts running if the value of the torque
boost (F09) is increased.
Increase the value of the torque boost (F09).
Check that there is no noise in the external signal wires.
Isolate the control signal wires from the main circuit wires as
far as possible.
Use shielded wire or twisted wire for the control signal wires.
What to Check and Suggested Measures
Check if an undervoltage trip occurs.
Change the data of function code F14 to 4 or 5.
Check the input signal with Menu #4 "I/O checking" using the
keypad.
Check the power recovery sequence with an external circuit.
If necessary, consider the use of a relay that can keep the
run command on.
What to Check and Suggested Measures
Check if the inverter is running with Menu #3 "Drive monitoring"
using the keypad and then confirm whether the data of the
function codes can be changed when the motor is running by
referring to the function code tables.
Stop the motor then change the data of the function codes.
Check the data of function code F00.
Disable data protection of function codes.
6-7