Recommended Wire Sizes - IMO Jaguar CUB Instruction Manual

(2) Arrangement of the control circuit terminals (common to all Jaguar CUB models)
30A 30B 30C
Screw size: M 2.5 Tightening torque: 0.4 N•m
Table 2.4 Control Circuit Terminals
Terminal Screwdriver to be used
Phillips screwdriver
30A, 30B, 30C (JIS standard)
No.1 screw tip
Phillips screwdriver for
precision machinery
Others
(JCIS standard)
No.0 screw tip
* Manufacturer of stick terminals: WAGO Company of Japan, Ltd. Refer to Table 2.5.
Table 2.5 Recommended Stick Terminals
Screw size Wire size
M2
AWG24 (0.25 mm
AWG22 (0.34 mm
M2 or M2.5
AWG20 (0.50 mm
AWG18 (0.75 mm
The length of bared wires to be inserted into stick terminals is 5.0 mm or 8.0 mm for the short or long type,
respectively.
The following crimping tool is recommended: Variocrimp 4 (Part No.: 206-204).

2.3.3 Recommended Wire Sizes

Table 2.6 lists the recommended wire sizes. The wire size for the main circuit denotes the values for
HIV and IV solid wires proceeding and following a slash (/), respectively, at an ambient temperature
of 50 C.
Y1 Y1E FMA
11 12 13
Screw size: M 2 Tightening torque: 0.2 N•m
Bared wire
length
Allowable wire size
AWG22 to AWG18
6 to 8 mm
2
(0.34 to 0.75 mm )
AWG24 to AWG18
5 to 7 mm
2
(0.25 to 0.75 mm )
Type (216-
With insulated collar
Short type Long type
2
) 321 301
2
) 322 302
2
) 221 201
2
) 222 202
2-4
C1 PLC X1 X2 X3
11 CM FWD REV CM
Dimension of openings in
the control circuit termi-
nals for stick terminals*
2.7 mm (W) x 1.8 mm (H)
1.7 mm (W) x 1.6 mm (H)
)
Without insulated collar
Short type Long type
151 131
152 132
121 101
122 102