Three-Phase 400 V Series - IMO Jaguar CUB Instruction Manual

8.1.2 Three-phase 400 V Series

*1 4-pole standard
*2 The rated capacity is for 440V output voltage.
*3 Output voltages cannot exceed the power supply voltage.
*4
Interphase voltage unbalance (%)
If this value is 2 to 3 %, use an AC reactor (ACR).
*5 Tested under the standard load condition (85% load for applicable motor rating).
*6 Calculated under specified conditions.
*7 Indicates the value when using a DC reactor (option).
*8 Average braking torque obtained with the AVR control off (F 05 =0). (Varies according to the efficiency
of the motor.)
*9 Average braking torque obtained by use of an external braking resistor (standard type available as
option).
*10 To make Jaguar CUB compliant with category TYPE1 of the UL Standard, Note that the
TYPE1-compliant Jaguar CUB should be used in the ambient temperature range from -10 to +40 C.
Note: A box ( ) in the above table replaces the E suffix for filtered version.
Max.voltag e (V) - Min.voltag e (V)
= 67
3 - phase average voltage (V)
8-2
(Refer to IEC 61800 - 3 (5.2.3))