Data Setting; Data Checking; Drive Monitoring; I/O Checking - IMO Jaguar CUB Instruction Manual

3.2.2 Programming Mode
Programming mode provides you with these functions--setting and checking function code data,
monitoring maintenance information and checking input/output (I/O) signal status. The functions can
be easily selected with the menu-driven system. Table 3.2 lists menus available in Programming
mode. The leftmost digit (numerals) of each letter string indicates the corresponding menu number
and the remaining three digits indicate the menu contents.
When the inverter enters Programming mode from the second time on, the menu that was selected
last in Programming mode will be displayed.
Table 3.2 Menus Available in Programming Mode
LED
Menu # Menu monitor
shows:
1.F_ _
1.E_ _
1.C_ _
#1

"Data setting"

1.P_ _
1.H_ _
1.J_ _
1.y_ _
"Data check-
2. EP
#2
ing"
"Drive moni-
3.oPE
#3
toring"
4. _o
#4

"I/O checking"

"Maintenance
5.CHE
#5
information"
"Alarm infor-
6.AL
#6
mation"
7.CPy
"Data copying"
#7
Main functions
F codes
(Fundamental functions)
E codes
(Extension terminal functions)
C codes
(Control functions of frequency)
P codes
(Motor parameters)
H codes
(High performance functions)
J codes
(Application functions)
y codes (Link functions)
Displays only function codes that have been
changed from their factory defaults. You may refer to
or change those function codes data.
Displays the running information required for main-
tenance or test running.
Displays external interface information.
Displays maintenance information including accu-
mulated run time.
Displays the latest four alarm codes. You may refer
to the running information at the time when the alarm
occurred.
Allows you to read or write function code data, as
well as verifying it.*
* To use this function, you will need a remote keypad (option).
3-3
Refer to:
Selecting each of
these function
Section
codes enables its
3.4
data to be dis-
played/changed.
Section
3.5
Section
3.6
Section
3.7
Section
3.8
Section
3.9
--