IMO Jaguar CUB Instruction Manual page 48

3.3 Operation in Running Mode
If the inverter is turned on, it automatically enters Running mode in which you may operate the
following:
(1) Run/Stop the Motor
By factory default, pressing the
running the motor in the forward direction and
pressing the key decelerates the motor to
stop. The key is enabled only in Running
mode.
Changing function code F02 data makes it
possible to run the motor in the reverse direction
by pressing the key, determine the motor
rotation direction by entering input signals to the
terminals, and control the motor by pressing the
/ keys.
■ Operational relationship between function code F02 (Running/Stopping and Rotational
Direction) and key
If Function code F02 Pressing the
is set to:
2 in the forward direction
3 in the reverse direction
For setting "0" or "1" to F02, refer to Chapter 5 for details.
(2) Set up the Set Frequency and Others
By using the potentiometer and
quency and PID process commands. It is also possible to set up the set frequency as frequency, load
shaft speed, line speed, and constant rate of feeding time by setting function code E48.
Setting up the set frequency with the built-in potentiometer (factory default)
If you set function code F01 to "4: Enable the built-in potentiometer" (factory default) and select
frequency command 1 with function codes E01 through E03 (Hz2/Hz1 = OFF), then the potenti-
ometer becomes enabled to set up the set frequency.
key starts
key ro-
tates the motor:
/ keys on the keypad, you may set up the desired set fre-
3-6