Concluding Steps - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

System board and components
Installing processors on the new system board
"Installing the processor" on page
Ê
Installing protective socket covers on the defective system board
I
Since the defective system board is sent back for repair, protect the
delicate processor socket springs with a socket cover.
"Opening the load plate" on page 288
Ê

14.7.4 Concluding steps

Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: see section
– Memory modules: see section
page 280
I
Install all memory modules into their original slots.
– Expansion cards: see section
I
Install all expansion cards into their original slots.
– UFM: install the UFM spacer to the system board and install the UFM see
section "Installing the UFM" on page 367
– TPM (if applicable): see section
– DynamicLoM module (if applicable) see section
DynamicLoM module" on page 256
in place of the DynamicLoM module.
"Installing the fan box" on page 156
Ê
"Reassembling" on page 61
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility Reference Manual.
408
287.
"List of used cables" on page
"Installing processor heat sinks" on page 307
"Installing a memory module" on
"Installing expansion cards" on page 178
"Installing the TPM" on page 376
Upgrade and Maintenance Manual
411.
"Installing the
or the three screws that are installed
RX2540 M1