Disconnecting Power Cords - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Basic hardware procedures
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section
4.3

Disconnecting power cords

Removing the server from the mains
I
If there are installed two power supplies remove both power cords.
Figure 2: Removing the power cord from the PSU cable clamp
Ê Open on the locking lever on the PSU cable clamp (1).
Ê Disconnect the power cord from the PSU and remove it from the cable tie
(2).
54
"Locating the defective server" on page
Upgrade and Maintenance Manual
51.
RX2540 M1