Installing The Fbu (Riser Module 2); Concluding Steps; Ê "Reassembling - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

9.6.3.11 Installing the FBU (riser module 2)

Figure 134: Installing the second FBU with the holder
Ê Install the second FBU as described in section
page 216.
Ê Connect the FBU cable to the RAID controller.
Ê Route the cables as shown.

9.6.3.12 Concluding steps

"Reassembling" on page 61
Ê
Ê If applicable, connect all external cables to the expansion card.
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
Ê If applicable, "Updating RAID controller firmware" on page
Ê If applicable, "Enabling Option ROM scan" on page
"Enabling SVOM boot watchdog functionality" on page 86
Ê
RX2540 M1
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the FBU" on
82.
81.
229