Removing A Gpgpu Card (Fl); Installing The Rear Cover (Riser Module 1Riser Module 1); Installing The Slot Cover (Riser Module 1); Insert The Riser Module 1 (Hl) - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

9.6.2.4

Removing a GPGPU card (FL)

Figure 127: Removing a GPGPU card from a riser module
Ê Remove two screws (see circles).
Ê Carefully remove the GPGPU card from its slot.
9.6.2.5

Installing the rear cover (riser module 1riser module 1)

Ê Install the rear cover as described in section
module 1)" on page 195
9.6.2.6

Installing the slot cover (riser module 1)

Ê Install the slot cover as described in section
module 1)" on page
9.6.2.7

Insert the riser module 1 (HL)

Optionally you can install the riser module. In this case proceed as follows:
RX2540 M1
195.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the rear cover (riser
"Installing the slot cover (riser
223