Removing A 3.5-Inch Dummy Module - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.2.2.2

Removing a 3.5-inch dummy module

Figure 22: Removing a 3.5-inch dummy module
I
Dummy modules have been installed into unused HDD bays. Before
installing an additional HDD, the dummy module needs to be removed
from the desired drive bay.
Ê Carefully remove the lock (1).
Ê Press on the locking tabs on both sides of the dummy module to disengage
the locking mechanism (2).
Ê While keeping the locking tabs pressed, pull the dummy module out of its
bay (3).
V
CAUTION!
Save the dummy module for future use.
Always replace dummy modules into unused HDD bays to comply
with applicable EMC regulations and satisfy cooling requirements.
116 Upgrade and Maintenance Manual
RX2540 M1