Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual page 227

Figure 130: Installing the riser module 2
Ê Insert the riser module.
I
Make sure that the riser module engages properly in the recesses
(see picture before).
Ê Carefully push down the riser module.
Ê Fasten the riser module with five screws (see circles).
Figure 131: Connecting the power cable
Ê Connect the power cable to both connectors on the GPGPU and the
connector PWR 12V 3 on the system board as shown.
RX2540 M1
Upgrade and Maintenance Manual
Expansion cards and backup units
227