Loading The Medium; Loading A Roll Medium - GRAPHTEC CE5000-120AP User Manual

Setting up The Cutter Plotter

2.3 Loading the Medium

Load the medium, aligning it with the right-hand grit roller when viewed from the front so that it registers with
the media sensor. Then, adjust the push-roller position to match the width of the medium. The cutting plotter
can use media in roll or sheet form. Load the desired medium type by following the appropriate instructions.

Loading a Roll Medium

Load the roll medium onto the stock shaft on the stand.
(1) Confirm that the roll is correctly oriented, and then slide the stoppers onto the shaft.
Position the stoppers at the appropriate locations and then tighten the screws. At this time, if
you have loaded a 950-mm media roll, fix the stoppers at the positions shown in the following
diagrams. If the media roll is of a different width, loosen the stopper screws, align the roll with
the plotter's grit roller positions, and then tighten the stopper screws.
(2) Mount the stock shaft at the front of the cutting plotter.
2-4
Stopper
Stock shaft
Medium Stopper screw
Stopper Stock shaft
Approx. 20 mm
Mount the collar so that its side with
the smaller diameter contacts the white
plastic part of the shaft holder.
For 2-inch diameter cores
Collar Medium
For 3-inch diameter cores
Stopper
Stopper screw
Stopper screw
Stopper Stock shaft
Approx. 32 mm
Mount the collar so that its side with
the smaller diameter contacts the white
plastic part of the shaft holder.
Collar