MANUAL PROVISIONING
DISCOVERY
Users could manually discover the device by specifying the IP address or scanning the entire network.
Three methods are supported to scan the devices.
•
PING
•
ARP
•
SIP MESSAGE (OPTIONS)
Click on "Auto Discover", fill in the scan method and scan IP. The IP address segment will be automatically
filled in based on the network mask detected on the UCM61xx. If users need scan the entire network
segment, enter 255 (for example, 192.168.40.255) instead of a specific IP address. Then click on "Save" to
start discovering the devices within the same network.
The following figure shows a list of discovered phones. The MAC address, IP Address, Extension (if
assigned), Version, Vendor, Model, Connect Status, Create Config, Options (Edit/Delete) are displayed in
the list.
Firmware Version 1.0.1.22
Figure 19: Auto Discover
Figure 20: Discovered Devices
UCM6102/6104/6108/6116 USER MANUAL
Page 44 of 138