Xerox Phaser 6250 Service Manual page 120

Troubleshooting Procedure Table (Continued)
Steps Actions and Questions
16 Remove the Tray 3 Feed Solenoid connector
J824;
Is J824-1 <=> J824-2 less than 100 ohms?
17
Verify the voltage between P/J83-11 <=> P/
J81-1 on the Circuit Board LTA is +24 VDC.
18 Check the OPT Feeder Plug Assembly to the
LTA Main Assembly to the Tray 3 Harness
Assembly for continuity.
See "Paper Tray 3" on page 10-29.
3-38 Phaser 6250 Color Laser Printer Service Manual
Yes No
Go to Step 17. Replace the Tray
3 Feed
Solenoid,
PL 14.4.17. or
PL 15.4.17
Go to Step 18. Replace the
Lower Feeder
Circuit Board,
PL 14.5.1 or PL
15.5.1.
Replace the Replace the
Engine Control open Harness
Board, Assembly.
page 8-107.