Jam At Registration Roller: Jam Rr - Xerox Phaser 6250 Service Manual

Jam at Registration Roller: Jam RR

Check the paper path especially in the area of the registration roller and turn
chute assembly for obstruction or debris.
Try picking paper from a different tray.
Ensure the media being used is a supported type.
Remove, fan, and reload the media.
Cycle printer power.
If the problem persists, follow the procedure below.
Note
In some instances the error code will clear after power is cycled to the
printer, but will reappear with the next print. Check for a piece of paper fan-
folded behind the turn chute assembly or below the registration roller.
Troubleshooting Reference Table
Applicable Parts
Chute Assembly Registration, PL 9.1.6
Troubleshooting Procedure Table
Steps Action and Questions
1 Check the following for evidence of fault
or damage.
Registration Actuator, PL 9.1.9
Chute Assembly Registration, PL 9.1.6
2 Use service diagnostics to test the
Registration Sensor.
Does sensor function correctly?
3 Check that the connection between the
Harness and the Registration Sensor is
properly connected and seated.
4 Check J181 <=> J18 on the Registration
Clutch Harness for continuity.
See "Paper Feed" on page 10-25.
5 Verify the voltage between P/J 18-3 <=>
P/J 18-2 on the Engine Control Board is
0 VDC.
3-28
Wiring and Plug/Jack Map References
"Paper Feed" on page 10-25
Phaser 6250 Color Laser Printer Service Manual
Yes
Clean or replace
the parts
concerned.
Go to Step 6.
Go to Step 4.
Go to Step 5.
Go to Step 6.
No
Go to Step 2.
Go to Step 3.
Reconnect
properly.
Replace the Chute
Assembly
Registration,
page 8-71.
Replace the
Registration
Sensor,
page 8-73.