Xerox Phaser 6250 Service Manual page 95

Test
Tray 2 Low
Paper
Tray 3 Low
Paper
Tray 4 Low
Paper
Tray 1 (MPT)
No Paper
Sensor
Tray 2 No
Paper Sensor
Tray 3 No
Paper Sensor
Tray 4 No
Paper Sensor
Transfer Roll
Toner Full
Sensor
Image Unit Not
Installed
Sensor
Fuser Fan
Alarm Sensor
Rear Fan
Alarm Sensor
CTD (ADC)
Sensor
Error Messages and Codes
Front Panel Display and Test Definition
Size: XXXX
Paper is Not Low
Paper is Low
Paper is Not Present
Paper is Present
Paper is Not Present
Paper is Present
Toner Waste [Not] Full
Image Unit is [Not] Present
Fuser Fan Alarm Sensor is: OK
Failure
Rear Fan Alarm Sensor is:
OK
Failure
Dark Value: #
Light Value: ###
Sensor OK
Move the Rear Guide in the paper
tray to the desired paper size and
verify the sensor output matches
the paper size selected.
Insert and fill Tray [2] [3] [4] with
paper to the fill line.
Insert one sheet of paper in Tray
[2] [3] [4] to change the sensor
state.
Insert Paper into Tray 1. Toggle the
Tray 1 No Paper Actuator
(PL6.1.37) to change the state.
Insert Tray [2] [3] [4] with an
adequate amount of paper.
Toggle the No Paper Actuator.
Block the Toner Full Sensor
(PL5.1.13) to change the sensor
state.
Open Door C to change the state
of the Switch.
Status only
Note: Perform a test print
immediately prior to performing
this test.
Status only
Note: Perform a test print
immediately prior to performing
this test.
Status only
Remove the transfer roller to
observe change of state.
3-13