Fuser Removal; Toner Cartridge Removal - Xerox Phaser 6250 Service Manual

Fuser Removal

Warning
The Fuser may be hot. Turn off power and allow at least 5 minutes for the Fuser
to cool before removal.
1.
Power down the printer.
2.
Open Door B.
3.
Open Door C.
4.
Release the lock on each side of the Fuser, grasp the green handles and lift the
Fuser straight up off the mounting studs.

Toner Cartridge Removal

Caution
Clean up any toner spills using a Type II Toner Vacuum only. Never use a damp
cloth to clean up spilled toner.
If you are removing a toner cartridge to facilitate removal of other components,
replace the toner cartridge as soon as those components have been removed.
Keeping the toner cartridges locked into place prevents contamination of the
toner system and also prevents spillage.
1.
Power down the printer.
2.
Using the lips on both sides, lift the Top Cover (Output Tray) off of the printer.
3.
Rotate the locking lever on the end of the cartridge (or cartridges) being removed
to the back unlocked (closed) position and lift the cartridge out of the printer.
Note
Some toner will probably adhere to the bottom of the cartridge, so do not set the
cartridge on any surface that will be damaged by the toner.
Service Parts Disassembly 8-5