Xerox Phaser 6250 Service Manual page 61

8. Gear Idler Feed:
9. Feed Solenoid:
Assembly by controlling the rotations of the Gear Feed.
10. Low Paper Sensor:
When the actuator lowers to a pre-determined postion, it blocks the sensor beam
to trigger a low paper status. The actuator position can be seen from the front of
the paper tray allowing confirmation of the print media quantity.
11. Paper Feed Roll:
12. Roll Turn Assembly:
main drive through the turn clutch and transports the print media out of the paper
tray to the registration roller.
High-Capacity Feeder Trays 3 and 4
Note
The callouts in the following figure refer to the identifying numbers in the
preceding paragraphs. The T3 and T4 in the callouts identify the tray.
Tray 2 paper pick assembly has a different part number than the HCF Tray 3 and
Tray 4 paper pick assembly.
12(T3)
12(T4)
Theory of Operation
See Paper Pick Rollers.
Controls the operation (rotation/stop) of the Feed Roller
The actuator lowers as print media is used in the tray.
See paper Pick Rollers.
The roll turn assembly receives drive energy from the
11(T3)
3(T3)
2(T3)
2(T4)
11(T4)
3(T4)
4(T3)
9(T3)
5(T3)
5(T4)
9(T4)
4(T4)
6250-446
2-21