Xerox Phaser 6250 Service Manual page 109

Troubleshooting Procedure Table (Continued)
Steps Action and Questions
10 Install the current the FMS snippet
6250FMSFix.psx.
Download this snippet from the Partner or
Customer Support web sites.
NOTE The printer must be at the Ready state
to receive the snippet.
Following installation, a page prints with the
lines:
Printer updated successful!: [219/219]
Power printer OFF then ON to finish
upgrade.
If the snippet did not installed correctly, the
page reads:
PRINTER UPDATE UNSUCCESSFUL! [199/
199]
Wait until the printer is in READY State
and resend file.
Does the problem persist?
11 Check the Fuser for wear, damage, or debris.
Replace if necessary.
Does the problem persist?
12
Check for paper jammed in the Turn Chute
Assembly.
Is the leading edge accordian folded at the
Turn Chute?
13 Use Service Diagnostics to test the following
parts within the Registration Chute Assembly:
Replace any defective parts.
Does the problem persist?
14 Replace the Registration Chute Assembly
(page 8-71).
Does the problem persist?
15 Replace the Feed Rollers (page 8-18).
Does the problem persist?
Error Messages and Codes
Registration Sensor (PL9.1.8)
OHP Sensor (PL9.1.12)
Registration Clutch (PL9.1.6)
Yes
Go to Step 8.
See Jam at
Registration
Roller
(page 3-28).
Go to Step 13.
Go to Step 14.
Go to Step 15.
See Jam at
Registration
Roller
(page 3-28).
No
Go to Step 9.
Complete.
See Jam at
Registration
Roller
(page 3-28).
Complete.
Complete.
Complete.
3-27