Oki OKIFAX4550 Maintenance Manual page 83

T.F.
Item
No.
37 Fax2Net Function
38 Top Feed
39 Bottom Feed
40 G3/G4 Learning
41 LLC Check
42 G3 Setup BC
43 G3 Fallback Cause (54 kinds of
service code)
41309401TH Rev.4
Table 2.2 (8/8) Service Personnel Initial Settings
Set up whether to make Fax2Net service.
ON:
OFF: Disable
* The following Fax2Net service can use only
when Fax2Net function is set to ON.
Web Retrieval/Broadcasting/Prepaid Regis-
tration
Adjusts read start position of various machines.
-10 to +9 mm (in steps of 1 mm)
Adjusts read end position of various machines.
-2 to +10 mm (in steps of 1 mm)
Sets up whether to learn G3/G4 communication.
ON:
OFF: Not learn
* Setting disabled if without ISDN option.
Determine whether the lower layer compatibil-
ity information instracted from the calling side
is analyzed.
ON:
OFF: Not analyzed
* The setting data must be transferred to the
G4 board.
* Cannot be selected when G4 option board is
not installed.
Sets to send speech by BC of SETUP at
making a G3I call as there exists an ISDN-PBX
which accepts only the incoming call for
speech purpose (BC=speech)
Speech (for speech purpose)
3.1kHz (for communication Purpose)
Enables to select service code for automatic
fallback to G3 transmission if G4 transmission
is faulty. There are 54 kinds of service codes
that can be selected.
(Refer to G3 fallback service code list ).
The service code not selected is dealt with as
communication error.
Settings values:
Setting enabled only when G4 opt. is mounted.
Specifications
Enable
Learn
Analyzed
Default
83 /