Separation Rubber, Roller Assembly Sensor - Oki OKIFAX4550 Maintenance Manual

4.3.4

Separation Rubber, Roller Assembly Sensor

(1) Disassembly procedure
a) Separation rubber:
The separation rubber can be removed
from the Frame Assembly-Scanner (U).
b) Roller Assembly Sensor:
Remove the Plate-Support by removing
the two screws 1.
Note: Just fitting to two bossess.
c) Remove the two springs (L) and (R).
d) Remove the Roller Assembly-Sensor by
removing the Gear (Z31).
Note: When replacing the Roller
(2) Reassembly procedure
Reverse the disassembly procedure.
41309401TH Rev.4
Frame Assembly-Scanner (U)
Assembly Sensor, uses a Roller
with red mark.
Spring (L)
Red mark
View from A
Roller Assembly Sensor
Spring (R)
Earth Cable
Gear (Z31)
Bearing S
A
Plate-Support
161 /