Pc Loading By Manual Operation - Oki OKIFAX4550 Maintenance Manual

3.2

PC Loading by Manual Operation

3.2.1 Explanation on Procedure
Loading shall be performed as shown below when the PC loading function is selected by key operation
by a service man.
(1) Activate the MS(PC)-DOS with the host PC and the MFP connected via the Centro cable.
(2) Input the copy command from the MS(PC)-DOS on the PC to output the loading data file in binary
specification to the LPT1 in order to transfer the loading data to the MFP.
Example:
>copy/b xxx.x LPT1 (xxx.x is the loading data file name.)
(3) The user shall judge the normal end of data loading by checking the normal end of file output on
the PC and sounding of the buzzer indicating the normal end on the MFP. If the MFP displays
an error on the LCD, sounds the buzzer for an error or lights up the alarm LED, the user shall
judge abnormal end of data loading from the PC and repeat the procedure from step 2 after
turning the MFP power off once and to on again. (See "6. List of Error Causes and Corresponding
Codes" for the error cause.)
3.2.2 Procedural Sequence Diagram
MS(PC)-DOS in activated state
Start of loading data transfer by
means of the copy command
after checking the LCD
Waiting for transfer
Return to DOS prompt upon
completion of transfer
41309401TH Rev.4
PC
Confirmation by LCD indication or
buzzer sound
Loading data
MFP
"PC-LOADING" display in the upper row
on the LCD and ready buzzer sounding
after PC loading key operation
* If data receiving does not start in one
minute after setting ready for loading,
"ERROR CODE:OB" is displayed in
the lower row on the LCD and the
buzzer sounds to indicate an error.
(Press the stop key to return to the
standby state.)
"RECEIVING" display in the lower row
on the LCD during data receiving
Hash check and flash memory update
after the end of receiving
End buzzer sounding after "RESULT OK"
display in the lower row on the LCD upon
completion of flash memory update
Jump to initial
519 /