Oki OKIFAX4550 Maintenance Manual page 117

Table 2.8 (4/6) User's Initial Settings (Function Program)
P.F.
Item
No.
21 PC/FAX switch
22 No toner memory reception
(NO Toner MEM RX)
23 Memory full save (MEM Full
Save)
24 Continuous Tone
25 Instant Dialing
26 Restricted Access
41309401TH Rev.4
Specifications
To enable or disable PC interface function.
When PC reception is not available, for example,
application is not activated on the PC or cable is
missing between PC and fax etc., this setting
allows to switch from PC to fax reception auto-
matically.
ON: Automatically change to fax reception
OFF: No reception
Enables or disables the memory reception when
the fax is the toner low condition.
ON: Receives the message in the memory re-
ception when the fax is the toner low
condition. The messages are printed when
toner has been newly supplied.
OFF: Prints the message even the remaining
toner level is low or none. Print quality is not
guaranteed.
Broadcast transmission and other features origi-
nate calls after all the document read in memory.
When Memory Full occurs during reading docu-
ments and operator time out occur, all the readout
data must be deleted (OFF setting) or all the data
must be sent (ON setting).
Select either ON or OFF setting as follows:
ON: Selecting display
OFF: Selecting delete at all times.
Note: Operator timeout means operator does
not respond during 59 seconds.
Setting of sounding warning tone after recep-
tion.
ON: Warning tone sounding stops by
operator's STOP key pressing
OFF: No warning tone
Setting to start reading documents upon call origi-
nation when transmitting.
ON: Dialing while document scanning
OFF: Dialing after document scanning
Restricted Access limits accessible users by set-
ting a password beforehand. Inputting the pass-
word then enables the user's access to the ma-
chine (FAX terminal).
ON: Enables Restricted Access
OFF: Disables
Default
117 /