Oki OKIFAX4550 Maintenance Manual page 82

T.F.
Item
No.
30 ID/TSI priority
31 Toner Count Clear
32 Parallel Pick Up
33 V.34 TX Retray
34 Symbol Rate
35 Leased Line
36 CED Send
41309401TH Rev.4
Table 2.2 (7/8) Service Personnel Initial Settings
Selects ID/TSI printing in the distant station ID
column of the report.
ID:
TSI:
Priority
1
2
3
4
Note: LCD display and Report printing gives
Enables or disables the clear operating of Toner
Counter Clear (OT7) without Service bit ON/OFF
(TF01).
ON:
OFF:
To control a receiving fax by 2 digits (the same
digits as remote reception) from a telephone set
connected parallel to the telephone line.
ON:
OFF:
(For the details, see Appendix A1, Section 4.3.
Outline of Parallel Pick Up.)
Determine whether the V.34 communication
error is to be remembered.
ON:
OFF: Not remembered
Set the V.34 modem symbol rate.
2400/2800/3200/3429 selectable.
Sets to leased line mode for China. When
setting to this mode, CML, DP, and SR relays
must be always set to ON. Sending on leased
line is performed with document ON, no
address designation and pressing of the
START key.
Receiving on leased line is performed by
answering automatically when detecting PIS or
CNG.
ON:
OFF: No leased line mode
Sets to send CED or not at the time of incom-
ing call.
ON:
OFF: Not sending CED
Specifications
Prints NSF signal with personal ID.
Prints TSI signal without NSF.
Set to ID
TX RX
Personal ID Personal ID
CSI TSI Dial No.
Dial ID Dial ID Personal ID
Dial No. Dial No.
preference to TSI/CSI signal than Per-
sonal ID.
Enables
Disables
To enable
To disable
Remembered
Leased line mode
Sending CED
Default
Set to TSI
TX RX
CSI TSI
Dial No.
Personal ID
- -
82 /