G3 Protocol Dump - Oki OKIFAX4550 Maintenance Manual

6.14.1 G3 Protocol Dump

Purpose:
To allow the serviceman to obtain a list of protocol signals transferred between the transmitter
and receiver.
Print conditions:
• Modem trace information for each TX/RX is printed. (Informeation for RX is added on 2nd
page.)
• Modem result code is printed.
• JM information is moved in the arrangement of CM information.
• "00" is printed always since the received SID on the 2nd page is invalid.
Method:
The report will be manually printed out for maintenance purpose. If the previous communication
is G3, G3 communication protocol dump is printed out. If it is G4, the G4 communication protocol
dump is printed.
1. Title of the report
2. Date and time when the report was printed
3. Sender ID
4. Date of communication
5. Time of communication
6. One message transmission/reception time
7. Identification of remote station
• CSI and/or telephone number
8. Mode of transmission/reception according to ITU-T designation
9. Total number of pages in communicaiton
10. Identification of the result of the communication
11. Service code
12. TX: DIS/DTC/DCS/NSF/NSS/NSC
13. Transmitted telephone number
14. Transmitted SEP/SUB
15. Transmitted SID
16. Common information of ITU-T V.34 TX/RX
17. Modem trace
18. RX: DIS/DTC/DCS/NSF/NSS/NSC (page 2)
19. Received telephone number
20. Received SEP/SUB (page 2)
21. Received SID (page 2)
22. Common information of ITU-T V.34 TX/RX (page 2)
23. Modem trace (page 2)
41309401TH Rev.4
204 /