Table of Contents
Advertisement
2.
Quick Set-up manual for RMCS Model 40
2.1
RMCS Installation
1)
Insert the disk to set up the RMCS in the drive.
2)
Start up Installer.
3)
Execute installation by following the SETUP screen.
* You can set an operator password during Install.
* You can skip password registration.
* You can use up to 15 alphanumeric characters to set up a password.
* You can change the registered password after installation.
* You can enter up to 15 alphanumeric characters for a password.
3.
Startup
3.1
Entering Operator ID
As the RMCS MODEL 40 starts up, you are queried for entering an operator ID.
You can confirm the operator ID you entered on the System Main screen or the Model Main screen
after the RMCS started up.
* You can enter up to 50 alphanumeric characters for operator IDs.
* If you want to change the operator ID, you must exit RMCS first, then re-boot it.
3.2
Entering Password
You are queried for entering a password at the same time as entering an operator ID.
1)
Enter an operator password.
* Enter the password that was registered during installation of the RMCS for Win or the password
modified later.
* If no password has been registered, you need not input any herein.
2)
Press the OK button.
* If you enter the password incorrectly three times, the RMCS closes and it does not boot up.
41309401TH Rev.4
526 /
Advertisement
Chapters
Table of Contents
Troubleshooting
