Oki OKIFAX4550 Maintenance Manual page 116

Table 2.8 (3/6) User's Initial Settings (Function Program)
P.F.
Item
No.
14 User language
15 Incoming ring
16 Remote receive
17 Memory and feeder switch
18 Power save mode
19 ECM function
20 Remote diagnosis
41309401TH Rev.4
Specifications
A choice of 2 languages for LCD and print mes-
sage are available. GER, FRE etc. are displayed
insted of OTHER.
ENGLI/OTHER selectable.
Instead of ringer circuit, software can control built-
in speaker to ring sound.
To enable (ON) or disable (OFF) or distinctive ring
(DRC) a software generated ring sound to indi-
cate arrival of an incoming bell.
This function is used to transfer a call received by
an external telephone set (connected to fax) by
entering two-digit MF tones if the remote receive
setting is not OFF
The following combinations are selectable.
00/11/22/33/44/55/66/77/88/99/**/##/OFF selectable.
Note: Parallel pick-up control inhibited when
this is set to OFF.
Switches the transmission mode between the
memory and feeder.
MEM. TX/FEEDER TX selectable.
Note: This function becomes effective when
Instant Dial of No. 25 is set to OFF.
The power supply will be fed to all circuits of a fax
machine whenever the fax goes to the operating
state. The power save mode has reduced the
power consumption at standby to below 0.5 W.
Note: Power save mode is not available
for ODA version. (including LTA, MEX)
Pre-heating time (Standby to print):
Approx 30 sec
Eanbles or disables power save mode
ON: Enables
OFF: Disables
Enables or disables ECM (error corection mode)
communication.
ON: Enables
OFF: Disables
Enables or disables the remote diagnosis function
when the machine can allow remote diagnosis
from remote center.
ON: Enables
OFF: Disables
Default
116 /