Oki OKIFAX4550 Maintenance Manual page 118

Table 2.8 (5/6) User's Initial Settings (Function Program)
P.F.
Item
No.
27 Width Reduction
28 Toner save
29 CNG Count
30 ISDN Dial Mode
41309401TH Rev.4
Specifications
This function can print characters written at the
edges of a document.
Switches the reduction of the horizontal scanning
direction.
ON: Reduction printing (216 mm to 203 mm)
Reduction rate is shown as below.
Copy
STD
A4 size 97.9%
Except A4 size 94.5%
Reception message
8 dot/mm 300 DPI
94.1% 92.6%
OFF: 203 mm printing
Determine whether toner saving is to be per-
formed furing fax printing.
When a LAN/PC printer is used, this setting is
ignored and the command from the host is ex-
ecuted.
1) Setting value
ON(Toner saving performed)/OFF(Toner
saving is not performed)
When T/F, TAD, or Parallel pickup is operatimg
in CNG signal detection processing, this setting
can be shifted to the facsimile reception mode at
the time of number of CNG signal detedction
times are equal to the set values.
1) Seting values
1 - 5 (in one-tray steps)
• Selection is skipped over when the ISDN
board is mounted (sellection allowed if
SERVICE BIT = ON).
Determine whether G4 communication is to be
performed by calling a signal remote machine by
pressing ten-keys when an G4 option is mounted.
1) Setting values
G3 MODE(G3 communication)/G4(G4 com-
munication)
• This setting cannot be made when an G4
option board is not provided.
Default
Fine EX Fine
97.5% 97.5%
95.0% 95.0%
118 /