Preparations Before Filling; Filling The Machine - Wexiodisk WD-6 Installation And User Manual

Instructions for use

4.1.2 Preparations before filling

Numbers in brackets refer to the diagram in the chapter "The machine's design".
Check:
•
•
•
•
Washing up liquid must not be used in the machine or for soaking dishes. It caus-
es foam to form and produces poor washing results.
Fit:
The level pipe (13), filters (12) and, where appropriate, the drain filter (15). The
rubber sleeve (14) must seal against the base plate.
Switch on the power using the 0/1 button (9).

4.1.3 Filling the machine

Numbers in brackets refer to the diagram in the chapter "The machine's design".
•
•
•
•
WD-6
that the dishwasher and all the removable components are clean and that
there is no dirt in the nozzles in the washing and rinsing arms (10, 18)
that the rubber sleeve (14) is undamaged.
that the stopcock is open
the amount of detergent and drying agent.
Switch on the power using the 0/1 button (9) on the panel. The display (3)
shows the temperature of the rinsing water. The other display (4) shows
"P0". P0 is a pause mode which indicates that no washing programme has
been selected.
Close the hood and the machine will start to fill. Filling and heating for a
standard machine take approx. 6 minutes at an incoming water tempera-
ture of 55° C. The heating time is dependent on the incoming water temper-
ature.
Once the machine is full, the symbol (1) lights up and the display (2) shows
the temperature of the washing water. If the washing temperature falls be-
low the set value by more than 5°C, the temperature shown on the display
(2) flashes.
The machine cannot start washing until the set temperature minus 5°C for
the washing water has been reached, if this function is selected. The nor-
mal operating temperature for the washing phase is 60° C. When the wash-
ing temperature falls below 50°C, the temperature display flashes.
30
Rev. 4,0 (201302)