Error Messages; Operating Problems - Wexiodisk WD-6 Installation And User Manual

Instructions for use

4.3.7 Operating problems

CODE CAUSE
IF01/ The time needed to fill the tank has been exceeded. The alarm can be reset by pressing 0/1 on the panel.
Er01
The level pipe is not in place.
The level pipe's rubber sleeve is not sealing against
the bottom plate.
The water stopcock is closed.
Er02 It has taken too long for the machine to heat up, com-
pared with the previous time.
Er04 Faulty temperature sensor.
Er05 Faulty temperature sensor.
IF06/ The booster heater is not cooled during the final rins-
Er06 ing phase.
The water stopcock is closed.
IF09 Alarm for changing the water.
IF10 Alarm for weekly cleaning.
Er12 The break tank has not filled with water.
Er16 The temperature in the booster heater is too low.
Er23 The hood does not open when the automatic hood
opener is used.
Er27 The machine has lost all its set values.
IF30 Low water level in the washing tank before washing. Check that the level pipe is closed. The alarm can be
The level pipe's rubber sleeve is leaking.
IF34 Detergent alarm.
The machine has run out of detergent.
IF35 The machine is started with the door/hood closed.
Er96 The motor safety cut-out for the pump has tripped.
Er97 One digital input is shorted to ground.
Er98 Communication fault between the CPU and the pan-
el card.
Er99 Communication fault between the computer and
panel cards.

Error messages

When the machine is operating, various alarms or information messages can ap-
pear on both the control panel displays. There is a distinction between IF and Er
alarms. IF alarms can normally be dealt with by the operator. If there is an Er
alarm, the service personnel must be called. Some IF alarms that have been dealt
with by the operator a few times will eventually change to Er alarms, meaning that
the service personnel must be contacted.
Each alarm has a number: 01, 02, 03 etc. The top display shows either IF or Er.
The bottom display shows the alarm number.
WD-6
ACTION
Fit the level pipe.
Adjust the level pipe. Check that the rubber sleeve
has not been damaged. Replace the sleeve, if it is
damaged.
Open the stopcock.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel if the alarm recurs.
Contact service personnel.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the panel.
Open the stopcock. Close the door.
Change the water. The alarm can be reset by press-
ing 0/1 on the panel. If the alarm is not set to stop the
machine, the washing programme can continue.
The machine must be cleaned more thoroughly than
during daily cleaning. The alarm can be reset by
pressing 0/1 on the panel.
The alarm is reset automatically when the tank is full.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel if the fault recurs.
Contact service personnel.
reset by pressing 0/1 on the panel.
Check that the level pipe's rubber sleeve has not
been damaged.
The alarm can be reset by pressing 0/1 on the panel.
Check the amount of detergent and refill, if neces-
sary.
Open and close the door/hood to acknowledge the
alarm
Contact service personnel.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel if the alarm recurs.
The alarm can be reset by pressing 0/1 on the panel.
Contact service personnel if the alarm recurs.
43
Rev. 4,0 (201302)