Wexiodisk WD-6 Installation And User Manual page 30

Installation
1. Check:
•
•
•
•
•
2. Filling the machine:
•
•
•
3. Start the machine:
•
•
•
4. Check the setting of the reference values:
•
•
5. Run a number of washes complete with loads and check that:
•
•
•
•
•
•
•
6. Final check: Empty the machine and turn off the power using the mains
switch.
•
•
•
7. Train dishwashing staff
WD-6
Water and drain connections
That the machine is evenly balanced
Detergent and drying agent
Filters and level pipe are in place
The overheating protection on the booster heater is set to zero.
Turn on the mains switch and any circuit breakers
Close the hood
Fill the machine with water in accordance with the INSTRUCTIONS FOR
USE
Check the pump's direction of rotation
Note: If the pump is rotating in the wrong direction, the phase must be in-
verted on the lockable mains switch.
Empty the machine and refill it
Check the final rinse flow during filling
Note: If the flow is correct, the machine will fill in 2 minutes and 15 seconds
(machine with standard equipment). The flow is regulated by the built-in
ball valve.
All the reference values have been set to the recommended values on de-
livery
Check the temperatures
There are no water leaks
The hood switch functions
The automatic hood lift functions (option)
The automatic hood closure functions (option)
The water temperatures are maintained
The washed items are clean
The washed items are dried
Note: The equipment for detergent and drying agent is roughly set at the
factory. Contact your detergent supplier for a more precise setting.
Re-tighten all the connections on the relays and any circuit breakers
Set all the circuit breakers to the ON position
Display the maintenance instructions supplied with the machine.
26
Rev. 4,0 (201302)