Draining And Internal Cleaning (Machine Without A Drain Pump); Draining And Internal Cleaning (Machine With A Drain Pump) - Wexiodisk WD-6 Installation And User Manual

Instructions for use

4.3.1 Draining and internal cleaning (machine without a drain pump)

When the machine is switched off, the number of baskets washed appears on the
display for approximately 5 seconds.
After this two horizontal dashes "--" are displayed for 3 minutes. At this point the
machine is still live and emptying and internal cleaning must take place within this
period. The machine then switches off automatically.
•
•
•
•
•

4.3.2 Draining and internal cleaning (machine with a drain pump)

When the machine is switched off, the number of baskets washed appears on the
display for approximately 5 seconds.
After this two horizontal dashes "--" are displayed for 3 minutes. At this point the
machine is still live and emptying and internal cleaning must take place within this
period. The machine then switches off automatically.
•
•
•
•
•
•
Position of clean components after washing
WD-6
Open the hood. Press button 0/1 (9). Take out the filters (12). Drain the
washing tank by removing the level pipe (13).
Close the hood. Press P3 (8). The display (2) shows "SC" and the internal
cleaning process starts. The other display (4) shows the remaining clean-
ing time. When the cleaning process is finished, both the displays show two
horizontal dashes "--".
Open the hood. Check that the washing and rinsing nozzles (10, 18) are
clean and that no objects have fallen and lodged in the machine.
Remove and clean the pump filter (16), the chemical washing filters (12)
and the level pipe (13).
Store the cleaned parts in a washing basket. Make sure that the rubber
sleeve (14) on the level pipe does not become deformed, by allowing it to
hang free.
Open the hood. Press button 0/1 (9). Take out the filters (12). Drain the
washing tank by removing the level pipe (13).
Close the hood. Press P1 (6). "dP" appears on the display (2) and the drain
pump starts. It stops automatically after a set period.
Once the machine has been emptied, close the hood. Press P3 (8). The
display (2) shows "SC" and the internal cleaning process starts. The other
display (4) shows the remaining cleaning time. After the cleaning process
has finished and the water has been emptied out, both the displays show
two horizontal dashes "--".
Open the hood. Check that the washing and rinsing nozzles (10, 18) are
clean and that no objects have fallen and lodged in the machine.
Remove and clean the pump filter (16), the chemical washing filters (12)
and the level pipe (13).
Store the cleaned parts in a washing basket. Make sure that the rubber
sleeve (14) on the level pipe does not become deformed, by allowing it to
hang free.
40
Rev. 4,0 (201302)