Settings Options For Detergent And Drying Agent Equipment (Option); Ac Or 230V Ac Power Supply For Detergent And Drying Agent Dosing Via Relay 9/J71 And Relay 11/J73 - Wexiodisk WD-6 Installation And User Manual

Installation
3.6 Settings options for detergent and drying agent equipment
(option)
Check which equipment is fitted to the machine before starting work.
Switch off the power supply to the machine at the mains switch before starting
work in the electrical cabinet.
The first section "24V AC or 230V AC power supply for detergent and drying
agent dosing via relay 9/J71 and relay 11/J73" explains how the contacts are
supplied with the relevant voltage.
The second section "Settings options for relay 9/J71 and relay 11/J73" describes
the different settings available and how they can be changed.
3.6.1 24V AC or 230V AC power supply for detergent and drying agent dosing
via relay 9/J71 and relay 11/J73
The detergent and drying agent dosage system can take its power from two relays
on the data card. The relays can be dead, with no power supply, (trigger function)
or they can be connected to a 24V AC or 230V AC supply to power the dosage
system. Each relay has a contact for connecting the equipment. Relay 9 for de-
tergent is connected via a 3-pin J71 contact. Relay 11 for drying agent is connect-
ed via a 2-pin J73 contact.
For right connection at X10 see the machines wiring diagram.
230V AC equipment should not draw more than 1.5A.
24V AC equipment should not draw more than 1.5A.
The time and method for switching on the relays is determined by the settings in
the table of reference values. See the section "Settings options for relay 9/J71
and relay 11/J73".
Relay 9/J71. Dead closing function (trigger function)
(230V/400V machine)
To use the closing function without a power supply, follow these instructions:
•
Relay 9/J71. 230V AC version (400V 3-phase machine)
To connect a 230V AC power supply to the contact, follow these instructions:
•
•
•
WD-6
Contact the equipment to be controlled to contacts J71-101 and J71-105.
Connect a blue 0.75mm² wire from connector N1, N2 or N3 in the electrical
cabinet to contact J71-102.
Connect a black 0.75mm² wire from connector X10 to contact J71-105.
Connect the equipment to be controlled to contacts J71-101 and J71-102.
There will be two wires connected to contact J71-102.
20
Rev. 4,0 (201302)